One of the most common problems of the IP security camera owners is forgotten passwords. We are receiving lots of calls or people asking through our chat window about this. So, we decided to help you to solve this issue for the brands we are currently selling. Check the list below to find out your default passwords or how to reset them if possible.
Acti
Username: Admin/admin
Password: 12345/123456
IP address: 192. 168.0.100
Arecont Vision
Arecont does not have a default password , but you can reset it to factory settings. Follow these steps:
1-Access the camera’s web interface by typing the IP in your web browser.
2-Under the Administration or System tab, click on Restore to Factory Default.
3-Once the camera reboots, all settings on the camera will be restored to factory default
AXIS
For an old system:
Username: Root
Password: Pass
But new generation AXIS security cameras have a resetting sequence:
1-Remove the Ethernet cable
2-Press and hold the control button and insert the Ethernet cable again while holding the control button.
3-Hold the control button until the amber lights turn on.
4-Then release the button .
5-Wait about 1 minutes.
6-When the amber lights turns into the green lights your camera is resetted and your passoword as well
BOSCH
None. You can reset the camera by pushing the reset button about 7 seconds. Or you can reset the NVR by removing the battery on the mainboard (not recommended, at your own risk)
DAHUA
Username: admin
Password: admin
GEOVISION
Username: admin
Password: admin
HIKVISION
For old models (before firmware 5.3.0)
Username: admin
Password: 12345
For new models you can reset password via SADP tool. Please click the link below and follow the instructions on the pdf file
Hikvision password resetting guide
LTS
Username: admin
Password: 12345
Messoa
Username: admin
Password: 1234
IP address: 192.168.1.30
Mobotix:
Username: admin
Password: meinsm
SAMSUNG Techwin
For old models
Username: admin
Password: 111111 or 1111111
For new models
Username: admin
Password: 4321
Speco
Username: admin
Password: 1234
SONY
Username: admin
Password: admin
Ubiquiti
Username: ubnt
Password: ubnt
Videocom
Username: admin
Password: 12345
Vivotech
None . You can choose your own password after setup. If you want to reset it
1-Press and hold down the reset button for at least 1 minute
2-Power on the camera until the red light flashes rapidly
Now your camera is back to factory default without any password.
